When you looking at the thread title, you might think, “Nah, it’s another damn boring Arduino Based Drum kit around, there’s nothing special about this stuff!” First of all, don’t be so sure about it, as you haven’t read the whole story yet…

Frankly, if you have the talent, it’s a piece of cake for you to build a sophisticated Arduino Based Drum set.

Since the kit contains all the required parts, you only need to supply the Arduino and the material to make the actual drum pads!

It’s very simple to build the circuit board, as all the instructions have been stated in the drum kit. All you need to do here is following the instruction thoroughly, and you can get the circuit done in a few minutes.

Same with the circuit part, it’s as easy as ABC to build the drum pads. Each drum pad contains three sections, which as:

The top layer – It protects the sensor from damage. In addition, it reduces the amount of noise from the drumstick hitting the sensor.

The middle layer – It has a piece of metal, where is transmitting the shock from the stick into the piezo sensor.

The bottom layer – It keeps the drum pad from rattling on the table.